Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
18 years ago

JTAG problem

HI !!:) Itry program FLEX10K.

I have strange problem: i open programmer in Qartus 7 but it's dont recognize my Jtag cabel/ it's write "no hardware"/

I tried program FLEX10K from MAXPLUS programer ant it's work/

plese help to solve this problem!!!!

4 Replies

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    18 years ago

    wow I so donkey!!! i have done it 20 times today/ i opened Hadware setup->

    add hadware->choose Byteblaster. but only one i haven't done - to choose in curently celected hadware --byteblaster/

    thanks for you !!! I'm going to work ill to morning
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    18 years ago

    "no hardware" means, that the ByteBlaster II hasn't been selected (respectively not yet installed) in programmer hardware setup. If ByteBlaster is selected but not recognized, the message is "hardware not connected".