Forum Discussion
CTu001
New Contributor
New ContributorJIC programming process shows successful, but the FPGA Configuration Sequence looks abnormal.
Debug information: device: 5CEFA4M13I7N MSEL[4:0] setting: 10011 related signal observation: nSTATUS is high nCONFIG toggled repeatedly CONF_DONE is low By the way, what is the difference be...
YuanLi_S_Intel
Regular Contributor
Regular ContributorHi Chien Hui,
The differences between 5CEFA4M13I7N and 5CEFA4M13C8N are the Operating Temperature and FPGA Fabric Speed Grade. You may refer to link below for more information about it:
https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyclone-v/cv_51001.pdf (Page 6)
The signal is weird. So, can the device be configured when the board is boot up?
Regards,
YL
