Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Is there a way to specify a wire inside FPGA?

Hi All, I have an I2C board that outputs GND, SCL and SDA for I2C implementation. I need the SCL and SDA I2C signals, including the bi-directional SDA to go through a Cyclone III FPGA from...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Thanks guys, I was going to try ALTDDIO_BIDIR but I saw that it was not just a bi-directional pass transistor.

I will have to physically connect the signals on the board on a bus outside of the FPGA.

RAUL