Forum Discussion
ISh
New Contributor
New ContributorI have a design that uses 10M16SAU169I7G. i noticed that every time I flash it, many I/Os (if not all of them) are going high, I even have a led connected that lights up.
i have done a blank check and even erased the device again, but nothing changes, still the device has many high voltage I/O's. my bank voltage is 3.3V. please advice why this happens and why the I/...
a_x_h_75
Contributor
Contributorhttps://www.intel.com/content/www/us/en/programmable/documentation/mcn1397700832153.html#mcn1397811237452
Table 17:
"Value of I/O pin (dedicated and dual-purpose) pull-up resistor before and during configuration, as well as user mode if the programmable pull-up resistor option is enabled"
Cheers,
Alex
