How to boot 2 NIOSIIs from single EPCS/EPCQ ?

Question

I can boot 2 niosIIs from parallel FLASH chip.  But  how to boot 2 NIOSIIs from single EPCS/EPCQ ?Are there any documents or samples about this!Thanks!​​

anandraj_s_intel · Answer

Hi,Refer below linkshttps://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/an/an736.pdfhttps://fpgawiki.intel.com/wiki/User_talk:Booting_NIOS_II_from_Altera_Serial_Flash_Controller_(EPCQ)_with_blinking_LEDs_design_exampleRegardsAnand

jt_l · Answer

​Thanks very much!In fact, in my design, I want to use two NIOSII IPs and the configration chip is only one EPCS/EPCQ.How can I boot up two  NIOSII IPs  from the signle  EPCS/EPCQ?  Are there any documents or samples ?Also, the net connections is not good. So the reply is delayed.Regards.

anandraj_s_intel · Answer

​Hi,Refer below link for more details and example. https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/tt/tt_nios2_multiprocessor_tutorial.pdfRegardsAnand

Forum Discussion

How to boot 2 NIOSIIs from single EPCS/EPCQ ?

3 Replies

Recent Discussions

Agilex5 Engineering Silicon

Agilex 7 with LTM4700 PMBus-Compliant Voltage Regulator

LTC Connector DE10-Standard FPGA

Does direct connection of two AXI4 Masters to DDR Slave support auto-arbitration on Agilex 5?

10AX115H3F34E2SG, Laser marking