Forum Discussion
Altera_Forum
Honored Contributor
Honored Contributorerror occurs when i changed my FPGA
first, i used the Cyclone, my program ran correctly. then, i changed it to Cyclone IV, then the error occurs. some controlling order in my program is wrong, i have not changed my program. so ,...
Altera_ForumHonored Contributor
Honored Contributor --- Quote Start --- what error? --- Quote End --- My program control different periphery devices, such as valves, stepmotors. when i changed my FPGA, the control signals are not correct, so these periphery devices can't work Normally.
