Forum Discussion
New ContributorError: No EPCS layout data - looking for section [EPCS-9D6017]
Error: No EPCS layout data - looking for section [EPCS-9D6017]
Error: Unable to use EPCS device
Error: Error code: 8 for command: nios2-flash-programmer "D:/ANSER_Proj/Altera_FPGA/TIJ_Engine_proj/software/TIJ_bsp/flash/DE10_NANO_TIJ_Engine_epcs_flash_controller_0.flash" --base=0x41000 --epcs --sidp=0x42138 --id=0x42138 --timestamp=1555660140 --device=2 --instance=0 '--cable=DE-SoC on localhost [USB-1]' --program --verbose
20 Replies
JohnT_AlteraRegular Contributor
The setting looks good to me.- JohnT_AlteraHi, Could you try the method mention in https://www.intel.com/content/www/us/en/programmable/documentation/iga1446487888057.html#jrn1481229919317 (Chapter Nios II Processor Booting from EPCQ Flash)? You will need to change the device to EPCS and Configuration mode to Active Serial Mode.
- JohnT_AlteraMay I know if you are able to use older version of Quartus which is 14.1? I would like to confirm if this is happening only in latest Quartus version only.
- RWeiz
- RWeiz
chapter 8.5 我有跟著做
- JohnT_AlteraHi, Do you follow the user guide from Terasic chapter 8.5?
- RWeiz
- RWeiz
我的JIC可以燒錄成功
configuration device: EPCS64
我的設備，版本
- RWeiz
Rev.C - JohnT_AlteraHi, That is what you set but I don't think EPCS64 is used on the board. Please confirm your board version.
- RWeiz
[EPCS-010216] # EPCS64N
sector_size = 65536
sector_count = 128
[EPCS-014017] # EPCS64N
sector_size = 65536
sector_count = 128
[EPCS-9D6017] # EPCS64N
sector_size = 65536
sector_count = 128
[EPCS-012018] # EPCS128
sector_size = 262144
sector_count = 64
[EPCS-FF] # EPCS64N
sector_size = 65536
sector_count = 128
