Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

epcs does not configure cyclone V

Hello, my ecps on my board does not configure my fpga. I create a jic file and programm the epcs.This works ok. But my programm does not boot. With the nios2flash programmer i can convert sof2...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

--- Quote Start ---

thanks for your suggestions.

The quartus settings are all ok. The MSEL[3..0] are set to AS Standard(10011)

i will look at my board .It must be something wrong at there.

Thanks

--- Quote End ---

an error from me: MSEL is a 5 Bit of course.

Could VCCBAT be a problem when sets to 1.8V?

thanks,