Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
10 years ago

En5364qi

Hi,

I have used

[h=1]EN5364QI for getting a 3.3V from 5V input, the schematic is attached. I see no voltage on Vout, may the problem be about the SS pin connected to GND?[/h]

Thanks for advance.

6 Replies

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    10 years ago

    From the datasheet...

    SS: A soft-start capacitor is connected between this pin to AGND. The value of the capacitor controls the soft-start interval and startup time.
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    10 years ago

    --- Quote Start ---

    From the datasheet...

    SS: A soft-start capacitor is connected between this pin to AGND. The value of the capacitor controls the soft-start interval and startup time.

    --- Quote End ---

    What happens when i connect SS directly to GND?
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    10 years ago

    It starts so softly that you never see a voltage at the output.

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    10 years ago

    --- Quote Start ---

    It starts so softly that you never see a voltage at the output.

    --- Quote End ---

    I have manufactured the pcb, so when i disconnect the SS and leave it no connect, can i see the voltage then? I am trying to know if a rework on pcb is worth it.

    Thanks
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    10 years ago

    --- Quote Start ---

    Try it and see.

    --- Quote End ---

    Today i will try ( leave Ss pin unconnected) and tell the results. You know its so hard to make that pin unconnected due to the package but i will try it with a technician.