Forum Discussion
ContributorDoes Intel publish a MAX based solution for configuring a Cyclone IV using FPP?
I think I'm going to have to switch from AS configuration to FPP configuration for my Cyclone IV GX 110 PCIe design to meet the boot time requirement. Is there a solution I can just drop in rather than having to roll my own? The Cyclone 10 GX development kit does something like this. My priority is to have something simple so I don't need to spend ages debugging it.
4 Replies
FvMSuper Contributor
Hi,
Parallel Flash Loader IP does just what you want.- Oliver_I_Sedlacek
Lots of develoment required by the look of that, which gets me back to wanting a real world example. Looks really risky if I don't know what the schematic should look like.
NurAiman_M_IntelHi,
You can use PFL IP for that. You can refer to board resource in link below as it uses PFL IP:
Regards,
Aiman
- NurAiman_M_Intel
We do not receive any response from you to the previous answer that I have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you
