Forum Discussion
Occasional ContributorDifferences between EPCQ and EPCQA
Hello,
I request the experts to answer the below questions:
1. What are the differences between EPCQ and EPCQA?
2. Which devices (EPCQ or EPCQA) are recommended for Cyclone10 FPGAs?
3. How do I decide the required size of EPCQ memory for my project? Can the required EPCQ size be predicted based on the size of .elf file or .jic etc.?
Thank you!
3 Replies
MBencaHi NShan12,
1. EPCQA is a newer device family for further information: AN 822: Intel® FPGA Configuration Device Migration Guideline, https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/an/an822.pdf
2. The list of recommended configuration devices for Cyclone 10 LP/GX: https://www.intel.com/content/www/us/en/products/programmable/configuration-device.html
3. Cyclone 10 LP: section 6.2.2. Configuration File Size, https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyclone-10/c10lp-51003.pdf
Cyclone 10 GX: Table 54. Configuration Bit Stream Sizes for Intel Cyclone 10 GX Devices, https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyclone-10/c10gx-51002.pdfBest regards,
Martin
NShan12Thank you Martin. These documents are useful.
- NurAiman_M_Intel
Super Contributor
Hi NShan12,
Thank you for contacting Intel community.
You can refer to Martin's solution above. Thanks Martin for your answer.
Let me know if you need further information.
Regards,
Aiman
