Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorDE1 Board broken??!
Hello, I added some extra hardware to the Terasic DE1 board by connecting it over the GPIO1 square header. When pressing the power button the board doesn't start up. When I remove my extra har...
Altera_ForumHonored Contributor
Honored ContributorHere are some pics of my setup:
http://dl.dropbox.com/u/41173070/pics/100_8114.jpg http://dl.dropbox.com/u/41173070/pics/100_8115.jpg http://dl.dropbox.com/u/41173070/pics/100_8116.jpg I didn't load any design on the fpga when I attached my additional hardware. It was the default configuration which normally doesn't use the GPIO ports.
