Forum Discussion

SYiwe's avatar
SYiwe
Icon for Occasional Contributor rankOccasional Contributor
7 years ago

DDR4 calibration failed

Hi, I instantiate a EMIF IP core with DDR4 protocol in my design, modify memory timing parameters and board skew values. The DDR4 speed bin is 2400 and CL=16. After programming the device in EMIF ...
BoonT_Intel's avatar
BoonT_Intel
Icon for Frequent Contributor rankFrequent Contributor
7 years ago

Hi,

If solder on board, mean it is not a DIMM device. Thus, choose - component.

SYiwe's avatar
SYiwe
Icon for Occasional Contributor rankOccasional Contributor
7 years ago

where can I found the process of calibration?

thanks, regards.