Forum Discussion

Shoval's avatar
Shoval
Icon for New Contributor rankNew Contributor
2 years ago
Solved

Cyclone V SoC GSRD precompiled SD boot failure

Hello all, I have recently tried to execute the GSRD on the Cyclone V SoC (https://www.rocketboards.org/foswiki/Documentation/CycloneVSoCGSRD) , the first step is to boot a precompiled SD image. I ...
Configuration
  • Shoval's avatar
    Shoval
    2 years ago

    Hello Aik,

    After checking the pin configurations you provided - nothing actually booted --> No UART prints on putty of any kind.

    Setting the following:

    J26: Short pins 1-2
    J27: Short pins 2-3
    J28: Short pins 1-2
    J29: Short pins 2-3
    J30: Short pins 1-2

    And the rest as you instructed:

    J5: Open
    J6: Short
    J7: Short
    J9: Open
    J13: Short
    J16: Open

    SW1: All OFF
    SW2: All OFF (modified)
    SW3: ON-OFF-ON-OFF-ON-ON (modified)
    SW4: OFF-OFF-ON-ON (modified)

    I was able to successfully boot and load FPGA from u-boot.

aikeu's avatar
aikeu
Icon for Regular Contributor rankRegular Contributor
2 years ago

Hi Shoval,


I am closing the thread for now.


p/s: If any answer from the community or Intel Support are helpful, please feel free to give best answer or rate 4/5 survey.


Thanks.

Regards,

Aik Eu