Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
13 years ago

Cyclone V: Communication with EPCQ Device in User Mode after Bootup

For my design, I'm using the Cyclone V (5CEFA7F23). I'm looking to boot the "factory image" from an EPCQ flash device using Active Serial x4, and then from the factory image (when in user mode), com...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
13 years ago

Did you ever resolve this issue? I am having this issue as well. It seems like the tool is not allowing me to assign these pins as user I/O after config as was possible in previous device families.