Cyclone III reflow temperatures

Question

Hi,

What is reflow temperature of Altera Devices?

I`m going to use EP3C10E144..

There are some notes about 240°C to 260°C but i`m not sure that`s about it.

Could the chip be damaged if the soldering was carried out at 350 degrees C?

Thanq for your attention

altera_forum · Answer

You should find some information here (http://www.altera.com/literature/an/an353.pdf). 350 °C is well outside the recommended temperature range, and I think you have a good chance of damaging the chip.

Forum Discussion

Cyclone III reflow temperatures

1 Reply

Recent Discussions

Cyclone-V SCFIFO - adding ECC to M10K/MLAB/Auto memory

Will serialization factor of 6 in LVDS serdes IP be supported in the future on Agilex5?

System PLL of Agliex5 PCIE example design cannot be locked after configuration

JTAG Chain Broken on Agilex 7-I Dev Kit

Request for Cyclone V Pinout File Information