Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorCyclone III Configuration
I have developed a custom board using Cyclone III (EP3C16E144C8) FPGA. I am using JTAG for programming and debugging purpose. I have attached the schematics for the configuration pins. The ...
Altera_ForumHonored Contributor
Honored Contributorhttp://www.altera.com/literature/hb/cyc3/cyclone3_handbook.pdf
Page#171 Cyclone III Device Family Configuration Schemes See if MSEL0,1,2 is correct for configuration mode you want. The Reset pin should be just weak pull-high right?
