Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

Cyclone III Configuration

I am bring up a board with a Cyclone III (256 pin). I have connectors for JTAG and the byte-blaster. MSEL0 = 0, MSEL1 = Vcca(2.5V), MSEL2 = 0. I can load the configuration via JTAG and I can ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

The original design used an oscillator with two ground pins, Vcc, and out. A replacement was used that had a standby pin, which in our design is grounded.

Ugh.

Thanks for the clue.

Rich