Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Cyclone III configuration problem

Hi I am using EPCS16 to configure Cyclone III EP3C25E device in AS mode. I load the pof configuration file into EPCS16 using external Speedpro 3000A third party programmer (JTAG is not used at all). ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Did you connect the exposed pad to GND? Did you provide all necessary pull-up resistors shown in the AS configuration schematic?