Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

Cyclone 3 E144 package getting hot and Cannot program the Cyclone using EPSC4 Chip

Thanks in advance, for any help you guys can provide . I'm trying to configure a Cyclone 3 (EP3C5E144) device using AS configuration mode. I'm currently using the EPCS4 chip for the AS mode configu...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

Thank you for the response. I've attached the diagram that I've used for my connections. Yes I was able to program using the AS mode, Quartus programmer had stated that I've successfully programmed the EPSC4 chip. But for some reasons, its not getting through to my Cyclone 3 as I've specified from description above. If you need any more specific information, I will gladly provide it.