Forum Discussion
New Contributorcustomizing soc_system.rbf for cyclone V
Hi
The steps you shared is getting the sd card image from the pre built source.
That is why you are seeing the old sysID still present.
Could you please follow the steps below :
Section " C. Prepare SD Card Image"
From the steps above you will pack the newly created rbf into the SD Card.
Regards
Jingyang, Teh
Regular ContributorHi
Since this thread been resolve, I shall set this thread to close pending. If you still need further assistance, you are welcome to reopen this thread within 20days or open a new thread, some one will be right with you. Please login to ‘https://supporttickets.intel.com’, view details of the desire request, and post a feed/response within the next 15 days to allow me to continue to support you. After 15 days, this thread will be transitioned to community support. The community users will be able to help you on your follow-up questions.
If you happened to close this thread you might receive a survey. If you think you would rank your support experience less than 4 out of 10, please allow me to correct it before closing or if the problem can’t be corrected, please let me know the cause so that I may improve your future service experience.
Regards
Jingyang, Teh
