Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorCPLD input question (by a primary user from china)
HI,Guys,I'm debuging EMP240T100。 I have set a signal "DONE" as input,and the pin doesn't connected to any device,but when I read it by DATA_BUS,it is '1', ps:DATA_BUS is a 16bits data bu...
Altera_ForumHonored Contributor
Honored ContributorIs 'Done' an input pin of the device? In that case, can you check if you have specified it correctly in the pin-options? And if it is a signal, then has there been any driver to that?
