Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
10 years ago

[Configuration Related] Cyclone III AP Configuration

Dear Host,

I am designing Cyclone III EP3C120 Board. On this board, i am configuring FPGA with AP configuration. In this configuration, i am using Micron P33 Parallel NOR Flash Memory.I will program the configuration through JTAG interfacing.

For VCCIO banks 1,6,7 and 8, i will use 3.3V.

Please provide additional information, if necessary.

Regards,

Mohsin Hayat

12 Replies

Show More
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    10 years ago

    I have one question about Passive Parallel Configuration......Is it possible we use NIOSII Processor and Cyclone III to interface with external Flash Memory without using CPLDs?

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    10 years ago

    It sounds like you're following the 'AP Configuration' section of the Cyclone III handbook. All the detail you need is in there. I'm not sure we can be expected to "provide additional information" here as well.

    Follow the design guidelines and you'll be fine. If you have specific questions ask them here.

    Cheers,

    Alex