RMoor29New Contributor6 years agoCan I program the MAX 10 using the Quartus Lite version and USBBlasterII ?
RMoor29New Contributor6 years agoThank you Aiman.N ,is there any tutorials available on set-up?For some reason Quartus does not recognize the blaster.
Recent DiscussionsTest_Timing_Closure_FAEPM7064LI44-15 – Xeltek SuperPro 610P Program OK but Verify fails at address 0x50There are distinct scratches on the BGA substrate, extending beneath the solder balls.Preconfiguration BSDL Editor for Agilex 7 with disabled F-TilesMAX 10 – Sporadic configuration failure after firmware update
