Forum Discussion

MOliv45's avatar
MOliv45
Icon for New Contributor rankNew Contributor
6 years ago

Best way to connect pin header to oscilloscope in an existing design?

I have ~100 cards that have 10 FPGA pins connected to a JST SH connector. I would like to connect some of these pins to a oscilloscope for latency measurements. What I have done so far is using hal...
SreekumarR_G_Intel's avatar
SreekumarR_G_Intel
Icon for Frequent Contributor rankFrequent Contributor
6 years ago

Can I know probe you using is FET based one ? Couple of years back I saw very good note from NXP about probing ..Sorry not remebering now which application notes.

if you able to maintain the 50 ohm on the measuring end , then defintely you will measure the perfect waveform.

Thanks