Forum Discussion

TG_GER's avatar
TG_GER
Icon for New Contributor rankNew Contributor
2 years ago

arria10 u-boot from sd card with early release

Hi, I am currently working with an Arria 10 board utilizing U-Boot and Yocto on an SD card. Presently, the device successfully boots with a full FPGA configuration and an autobootscript from U-Boot....
Configuration
tehjingy_Altera's avatar
tehjingy_Altera
Icon for Regular Contributor rankRegular Contributor
2 years ago

Hi


Since there are no feedback for this thread, I shall set this thread to close pending. Please login to ‘https://supporttickets.intel.com’, view details of the desire request, and post a feed/response within the next 15 days to allow me to continue to support you. After 15 days, this thread will be transitioned to community support. The community users will be able to help you on your follow-up questions.


If you happened to close this thread you might receive a survey. If you think you would rank your support experience less than 4 out of 10, please allow me to correct it before closing or if the problem can’t be corrected, please let me know the cause so that I may improve your future service experience.


Regards

Jingyang, Teh


  • TG_GER's avatar
    TG_GER
    Icon for New Contributor rankNew Contributor
    2 years ago

    Thank you very much for the response.

    I was on vacation for 2 weeks over Christmas and New Year's, and I'm now back.

    First of all, I wish you a Happy New Year.

    I just tried it again with the address you mentioned and also with the defined 'loadaddr',

    but unfortunately, I'm still facing the same issue.

    Could there be something in my config or in the device tree source (dts) that is not quite right?

    Best regards,

    Torben Geldermann.