Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
10 years ago

Arria 10 Fitter Error :Design requires contiguous fully bonded lanes

Hi all I was trying to compile my design in quartus 15.0 targeting the Arria 10 fpga device -10AX115R4F40I3SG.I ran just the tcl scripts for pin assignments present in the new Arria 10 EMIF-ddr...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
9 years ago

Hi Aswathy.p

I just got similar message as yours

Design requires 11 contiguous fully bonded lanes, but the target device for your design has a maximum of 24 contiguous lanes. Choose a different target device for your design.

From your message, it makes sense if the device has 8 and it requires 11. It is out of range.

But, my design requires 11 which is less than the device has.

Would mind to share how you did solve this issue?

I am using Arria 10 AX066 devices.

Thank you