About changing the configuration device

Question

Person in chargeI was using EPCS128SI16N in Cyclon4, but since it is a discontinued product, I am thinking of changing to EPCQ128ASI16N.I am using Nios2, but how can I write to this device?Is it possible to use the data used in EPCS128SI16N without performing synthesis again?Thank you.

fakhrula_altera · Answer

Hi taken,Please refer to Intel® FPGA Configuration Device Migration Guideline which provides futher instruction on migrating from the Serial Configuration (EPCS) and Quad-Serial Configuration (EPCQ) devices to the Quad-Serial Configuration (EPCQ-A) devices.Regards,Fakhrul

fakhrula_altera · Answer

As we do not receive any response from you to the previous notification that we provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.

Forum Discussion

About changing the configuration device

2 Replies

Recent Discussions

Questa licensing errror: "300 Your license version is outside the range of the contract".

JTAG Chain Broken on Agilex 7-I Dev Kit

[Agilex 5] Global Clock assignment ignored for PLL output clock with high fanout

Timing Behavior of Remote Update IP After Reset on Cyclone 10 GX (10CX150YF672E5G)

MAX10 fiftyfivenm encrypted module