Forum Discussion

New Contributor

5 years ago

A question about FPGA configuration

Hi,all I now using MX25L12833FMI-10G/MX25L12835FMI-10G to replace EPCQ128 to configurate CYCLONE V FPGA. The quartus II 18.1 show the successful configuration result. But when I power up the board...

NurAiman_M_Intel

Super Contributor

5 years ago

Hi ZCS,

Due to a problem in Quartus 18.1, the AS configuration fails in Cyclone V. Please try the workaround fix in below link:

https://www.intel.com/content/altera-www/global/en_us/index/support/support-resources/knowledge-base/component/2018/why-the-active-serial--as--configuration-fails-in-stratix-v--arr.html

Regards,

Aiman

ZC0001

New Contributor

5 years ago

Hi，Aiman.

Thanks for your reply.

I installed the patch for quartus, but it doesn't resolve this problem.

Can you give me some other advice. Thanks.

Best Regards

ZCS

NurAiman_M_Intel
Super Contributor
5 years ago
Hi,

Apologize for the delay in response.

Kindly use Quartus 18.1.1 and later.

https://www.intel.com/content/altera-www/global/en_us/index/support/support-resources/knowledge-base/component/2019/why-does-active-serial-configuration-fail-on-cyclone--v-fpgas-wi.html

Regards,

Aiman

Forum Discussion

A question about FPGA configuration

Recent Discussions

Thermal model for Max10 FPGA

Cyclone 10 GX AS x4 Configuration Compatibility with Infineon S25FS512S (Custom Flash Definition)

Drop-in replacement for EPCS64SI16N

ModelSim-Intel FPGA Starter Edition 18.1 exits with code 211 when pressing Restart button

MSEL and nCONFIG behavior at power up