Forum Discussion
New ContributorStratix 10: move data through the HPS SDRAM controller using the F2H AXI bridge.
Hello, I'm trying to master data from the FPGA to SDRAM. Which base address should I write to?
If there are examples out there I can use please link them. I can't find any.
4 Replies
EricMunYew_C_IntelFrequent Contributor
You can find the base address of the FPGA-to-SDRAM bridge in your Platform Designer.
ap_mercy
@EricMunYew_C_Intel wrote:
You can find the base address of the FPGA-to-SDRAM bridge in your Platform Designer.
@EricMunYew_C_Intel How can i confirm the bridge for FPGA-to_sdram bridge is enabled in the HPS?
- EricMunYew_C_Intel
The F2SDRAM bridge can be enabled in your Platform Designer, you may refer to the attached.
- EricMunYew_C_Intel
I’m glad that your question has been addressed, I now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.
