Forum Discussion

musthafavakeri's avatar
musthafavakeri
Icon for New Contributor rankNew Contributor
5 years ago

Stratix 10 FPGA programming not happening in Intel® Stratix® 10 DX FPGA Development Kit

Hi All, I want to program Stratix 10 FPGA in Intel® Stratix® 10 DX FPGA Development Kit. Following are some settings I have given in QSF file as per the board guideline ( https://www.intel.com/cont...
YuanLi_S_Intel's avatar
YuanLi_S_Intel
Icon for Regular Contributor rankRegular Contributor
5 years ago

Oh, the LED you meant is actually the LED connecting to CONF_DONE. This means that configuration is not successful. Do you have any error message? Can share me the error message obtained from Quartus Programmer?


  • eolse's avatar
    eolse
    Icon for New Contributor rankNew Contributor
    3 years ago

    I am having a similar issue. I can't program the Stratix DX development board. It fails at about 6%.

    I've updated the power management and VID according to the notes for supporting the emperion power management chips.

    It looks like my PMBus addresses are wrong. Here is the message:

    Error(18950): Device has stopped receiving configuration data
    Error(18948): Error message received from device: External hardware access error. (Subcode 0x0032, Info 0x00200008, Location 0x00001800)
    Error(22248): Detected a PMBUS error during configuration. Potential errors: VID setting is incorrect in the Intel Quartus Prime project. The target device fails to communicate to a smart regulator or PMBUS master on a board.
    Error(209012): Operation failed

    Can anybody help me with programming this device Please!