Forum Discussion

RFett's avatar
RFett
Icon for New Contributor rankNew Contributor
5 years ago

Error on attempt to download sof and jic file to Cyclon 10GX dev. board using JTAG. How to proper setup to get jic file programmed to EPCQL1024?

Using the C10 CVP sample project I added the Serial Flash Loader IP to the design into the top_hw.v. I setup the jtag chain for the Cyclon 10 GX Dev. Kit, download the 10 design (sof) -> ok and down...
RFett's avatar
RFett
Icon for New Contributor rankNew Contributor
5 years ago

Hello John

Thanks a lot, I appreciate your help! Due to Corvi 19 restrictions I can not try today.

Best regards

Roland

  • APPU_appu's avatar
    APPU_appu
    Icon for Occasional Contributor rankOccasional Contributor
    5 years ago

    @RFett

    Hii, may i how you created .hex file for that .jic file. And for EPCQL1024 flash how you assigned memory for .sof and .hex while creating the .jic file