Forum Discussion
mehta_expai
New Contributor
New ContributorProgramming a cyclone 4e device
Hello,
I have one FPGA driver board consisting CYCLONE 4E device. Whenever i am trying to program the device using JTAG blaster, quartus web edition software detect usb blaster but cyclone 4 e device not detected by quartus software.Sharing some screensnap,please take a look.
Thanks
2 Replies
ak6dnRegular Contributor
It would appear that the JTAG chain on your board is broken. Is it just the one Cyclone device in the chain?
I would use the JTAG debugger feature to check signal continuity.
Farabi_AlteraHello,
Quartus Web Edition is no longer supported , you may want to install Quartus Prime Lite Edition (Free) to get technical support.
regards,
Farabi
