OneAPI and FPGA boards support

Question

Hi,
I'm kinda new in the FPGA world and I'm a bit confused about oneAPI support to FPGA.
I want to buy an FPGA with an embedded processor, probably an Arria 10 SX, and program it using SYCL. However, I checked some online references on the Intel site but they only reference the Programmable Acceleration Card (PAC) versions. Is it possible to program with oneAPI the FPGAs mounted on a board?

aikeu · Answer

Hi Luigi-Crisci,You can try to use devcloud for oneAPI first to know better. There are a few types of boards which are supported in Devcloud.Refer to the link below to try out:https://github.com/intel/FPGA-Devcloud/tree/master/main/Devcloud_Access_Instructions#devcloud-access-instructionsThanks.Regards,Aik Eu

aikeu · Answer

Hi Luigi-Crisci,I will close this thread if no further question.Thanks.Regards,Aik Eu

Forum Discussion

OneAPI and FPGA boards support

2 Replies

Recent Discussions

DK-DEV-AGI027R1BES FPGA recovery

DK-DEV-AGI027RBES missing device selection

in MAX 10 Dev kit

DK-DEV-AGI027RES Install Package

DK-DEV-AGI027RES Install Package