Forum Discussion

himanshuvaria's avatar
himanshuvaria
Icon for Occasional Contributor rankOccasional Contributor
3 years ago

NIOS Processor does not boot using QSPI Flash.

Hello, I am trying to boot Nios II Processor from QSPI Flash on MAX10 dev kit. For that I have prepared one design that blink one LED via software(.hex). I performed all the steps mentioned in...
KellyJialin_Goh's avatar
KellyJialin_Goh
Icon for Frequent Contributor rankFrequent Contributor
3 years ago

Hi,

Any updates from your side after downloading the Parallel Flash Loader(PFL)? Can it flash now?


Regards,

Kelly


himanshuvaria's avatar
himanshuvaria
Icon for Occasional Contributor rankOccasional Contributor
3 years ago

Hello,

I am already being able to download the hex(.pof) file in the QSPI Flash by running the sof of Parallel Flash Loader Project into the MAX10 Dev Board. I have no issues in detecting the QSPI Flash and programming it in the programmer.

The issue here is that after programming the QSPI Flash the NIOS Processor does not boot on Power Cycle as per requirements.

You can further give your feedback on this issue.

Regards,

Himanshu