Forum Discussion

himanshuvaria's avatar
himanshuvaria
Icon for Occasional Contributor rankOccasional Contributor
3 years ago

NIOS Processor does not boot using QSPI Flash.

Hello, I am trying to boot Nios II Processor from QSPI Flash on MAX10 dev kit. For that I have prepared one design that blink one LED via software(.hex). I performed all the steps mentioned in...
KellyJialin_Goh's avatar
KellyJialin_Goh
Icon for Frequent Contributor rankFrequent Contributor
3 years ago

Hi,

Any updates from your side?


Regards,

Kelly


himanshuvaria's avatar
himanshuvaria
Icon for Occasional Contributor rankOccasional Contributor
3 years ago

Hello,

As suggested by you I have tried to boot MAX10 DEVICE by using general_serial_flash_interface_0 in my design. Still I am facing the same issue. The NIOS Processor does not boot. I have referred the following document for using general_serial_flash_interface_0:

https://www.intel.com/content/www/us/en/docs/programmable/683689/current/processor-application-copied-from-general.html

Kindly give your feedback for the root cause of this issue.

Thank You,

Himanshu