Forum Discussion

himanshuvaria's avatar
himanshuvaria
Icon for Occasional Contributor rankOccasional Contributor
3 years ago

NIOS Processor does not boot using QSPI Flash.

Hello, I am trying to boot Nios II Processor from QSPI Flash on MAX10 dev kit. For that I have prepared one design that blink one LED via software(.hex). I performed all the steps mentioned in...
KellyJialin_Goh's avatar
KellyJialin_Goh
Icon for Frequent Contributor rankFrequent Contributor
3 years ago

Hi,

Hi, yes go ahead with the GSFI settings that I suggested and change the IP from generic_quad_spi_controller_0 to general_serial_flash_interface_0. Follow the link above and screenshot for the GSFI IP settings that I posted, and you shall have a new hardware design for QSPI booting on your Intel Max10 devkit.


Thank you.

Regards,

Kelly