Forum Discussion
himanshuvaria
Occasional Contributor
Occasional ContributorNIOS Processor does not boot using QSPI Flash.
Hello, I am trying to boot Nios II Processor from QSPI Flash on MAX10 dev kit.
For that I have prepared one design that blink one LED via software(.hex). I performed all the steps mentioned in...
KellyJialin_Goh
Frequent Contributor
Frequent ContributorHi,
I have found more relevant information on how to boot using QSPI Flash with this link here: https://www.intel.com/content/www/us/en/docs/programmable/683689/current/processor-application-copied-from-general.html
For the qsys hardware design, you will need to change the generic_quad_spi_controller_0 to general_serial_flash_interface_0 and change the GSFI parameters according to the QSPI flash size.
Thank you.
Regards,
Kelly
KellyJialin_GohFrequent Contributor
Frequent Contributor
Hi,
Here is the GSFI IP settings that you need to change after changing your qsys design to a GSFI IP.
Thank you.
Regards,
Kelly
