Forum Discussion

Occasional Contributor

3 years ago

NIOS Processor does not boot using QSPI Flash.

Hello, I am trying to boot Nios II Processor from QSPI Flash on MAX10 dev kit. For that I have prepared one design that blink one LED via software(.hex). I performed all the steps mentioned in...

nios_boot_max10.zip1.7 MB

KellyJialin_Goh

Frequent Contributor

3 years ago

Hi,

Could you kindly log in to ‘https://supporttickets.intel.com’ to reopen this case so that I can support your question further.

Thank you.

Regards,

Kelly Jialin, GOH

Forum Discussion

NIOS Processor does not boot using QSPI Flash.

Recent Discussions

Mandelbrot viewer on Cyclone V - Platform Designer layout

Slow Runtime Performance in FIL Implementation on DE2-115 Using Ethernet

Device stopped receiving config data: Internal error (0x0000, 0x00000000, 0x1800).

Stratix 10 GX SI Board - issue with the Board Test System (BTS)

Stratix 10 Development Kit HiLo connector