Forum Discussion
Amir3
Occasional Contributor
Occasional ContributorJIC file format - after "Examine" operation , why is "Signal Tap" written?
Hello everyone,
In my system, from time to time some of the information in the Flash device goes wrong.
When I perform the "Examine" operation through the Programmer, I see that there is a dif...
Please notice that the .jic file header isn't read from the flash device rather than generated during programming file conversion respectively when storing the examined file. I don't know where the "Signaltap" text comes from, probably it has to do with the project loaded by Quartus at the time of examine operation. It doesn't tell anything about the .jic content.
Regards
Frank
Farabi_Altera
Regular Contributor
Regular ContributorHello,
We do not receive any response from you to the previous question/reply/answer that I have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.
regards,
Farabi
