Forum Discussion

Amir3's avatar
Amir3
Icon for Occasional Contributor rankOccasional Contributor
4 years ago
Solved

JIC file format - after "Examine" operation , why is "Signal Tap" written?

Hello everyone, In my system, from time to time some of the information in the Flash device goes wrong. When I perform the "Examine" operation through the Programmer, I see that there is a dif...
  • FvM's avatar
    FvM
    4 years ago

    Please notice that the .jic file header isn't read from the flash device rather than generated during programming file conversion respectively when storing the examined file. I don't know where the "Signaltap" text comes from, probably it has to do with the project loaded by Quartus at the time of examine operation. It doesn't tell anything about the .jic content.

    Regards

    Frank

FvM's avatar
FvM
Icon for Super Contributor rankSuper Contributor
4 years ago

Please notice that the .jic file header isn't read from the flash device rather than generated during programming file conversion respectively when storing the examined file. I don't know where the "Signaltap" text comes from, probably it has to do with the project loaded by Quartus at the time of examine operation. It doesn't tell anything about the .jic content.

Regards

Frank