Forum Discussion
Amir3
Occasional Contributor
Occasional ContributorJIC file format - after "Examine" operation , why is "Signal Tap" written?
Hello everyone,
In my system, from time to time some of the information in the Flash device goes wrong.
When I perform the "Examine" operation through the Programmer, I see that there is a dif...
Please notice that the .jic file header isn't read from the flash device rather than generated during programming file conversion respectively when storing the examined file. I don't know where the "Signaltap" text comes from, probably it has to do with the project loaded by Quartus at the time of examine operation. It doesn't tell anything about the .jic content.
Regards
Frank
Farabi_Altera
Regular Contributor
Regular ContributorHello Amir,
From time to time the information of your flash device goes wrong, could you please elaborate more on that.
Do the flash have issues during configuration? or when you try to program it?
regards,
Farabi
