Forum Discussion

CAlex's avatar
CAlex
Icon for Contributor rankContributor
3 years ago

How to start and run a baremetal aplication without the debug

Hi, I've managed to debug my code and now I want to test it on FPGA side. The issue is my board (cyclone V soc dev kit) has only one uart to Jtag yet I need to monitor the FPGA and HPS at the same ...
Jeet14's avatar
Jeet14
Icon for Frequent Contributor rankFrequent Contributor
3 years ago

Hi,


Please allow some time to check internally if there any guide available on this.

I will update ASAP.


Regards

Tiwari


CAlex's avatar
CAlex
Icon for Contributor rankContributor
3 years ago

Hi,

thank you for the reply,

The main thing is how to setup the Uboot(SPL?) so that the board know from where it should run the spl and from where it should run next(in my case it is the baremetal bin).

Looking forward to your reply

Reguards.