How to leave unused UFM Flash on MAX10 blank (0xFF)

Hi,

Could you provide me the step that you use to convert the sof and hex to POF file and the step you used to program the flash?

In Convert Programming Files:

• Select Internal Configuration
• In Options/Boot Info ... -- select UFM source: Load memory file, navigate to ./software/<project name>/mem_init/system_onchip_flash_0.hex, keep all defaults.
• Click "SOF Data" -- click Add File..., navigate to ./output_files/<project>.sof
• Keep default Programming file type: Programmer Object File (.pof)
• Click Generate

In "Programmer":

• Check the boxes for CFM0 and UFM in the Program/Configure column
• Click Change File ..., navigate to just created .pof
• Click Start and watch MAX10 get configured

Hi,

May I know how is the hex file genrerated? Do you observed the 1st sector of the "system_onchip_flash_0.hex" file is 0x0 or 0xff?

In NSBT, I do "Build Project", then "MakeTargets -> build -> mem_init_generate"

The "system_onchip_flash_0.hex" has 0x00 in scector 0 preceding my code and 0x00 everywhere after my code.

I will rename the .hex as .txt and add it here.

Hi,

You will either need to generate the hex file with unused sector to 0xFF or modify the hex file to make sure that the unused sector 1 to 0xff.

Modifying the .hex is not as simple as find 00 and replace with FF. I have to calculate checksum for the end of every line on too many lines.

Isn't there a way for Quartus tools to do it?

Hi,

I would recommend you to modify your Nios II BSP so that the unused memory is set as 0xFF. This will be easiest method as it will generate the hex file for you.

This is exactly what I need.

Can you please point me to instructions on doing it?

Hi,

Can you share with me your Nios II software BSP?

Hi,

If possible, please provide me the whole software folder to build Nios II software.