Forum Discussion

New Contributor

3 years ago

Error (14996): The Fitter failed to find a legal placement for all periphery components

I'm using Cyclone V GX board and in that lvds_rx and mipi ports are on bank 4a, so we need at least 2 pll ( one for lvds and one for mipi signals) The compiler is trying to place both in the sam...

Ash_R_Intel

Regular Contributor

3 years ago

Hi,

Thanks for sharing the design with us.

I ran the design and encountered fitter errors. Tool is complaining about more of pins in bank 4A than acceptable due to percentage of SSN that each pin contributes to. Recommend you follow the following article and the document referred in it:

https://www.intel.com/content/www/us/en/support/programmable/articles/000084790.html?erpm_id=9987570_ts1669713395072

Regards

Forum Discussion

Error (14996): The Fitter failed to find a legal placement for all periphery components

Recent Discussions

Mandelbrot viewer on Cyclone V - Platform Designer layout

Slow Runtime Performance in FIL Implementation on DE2-115 Using Ethernet

Device stopped receiving config data: Internal error (0x0000, 0x00000000, 0x1800).

Stratix 10 GX SI Board - issue with the Board Test System (BTS)

Stratix 10 Development Kit HiLo connector