Forum Discussion

BtsMalta2022's avatar
BtsMalta2022
Icon for New Contributor rankNew Contributor
3 years ago
Solved

EPM240T100I5N Architecture Variation !

Good morning, I require assistance to understand the difference in the architecture between two batched of the same product, namely EPM240T100I5N. The pictures below show the x-ray image & its ...
  • FakhrulA_altera's avatar
    FakhrulA_altera
    3 years ago

    Hi BtsMalta2022,

    Just got feedback from the internal. Both designs are normal. The “holes” below are not holes, but dimples on bottom of die pad. It is to enhance mold to die pad adhesion. This is a newer design.

    Regards,

    Fakhrul

FakhrulA_altera's avatar
FakhrulA_altera
Icon for Regular Contributor rankRegular Contributor
3 years ago

Hi BtsMalta2022,

Just got feedback from the internal. Both designs are normal. The “holes” below are not holes, but dimples on bottom of die pad. It is to enhance mold to die pad adhesion. This is a newer design.

Regards,

Fakhrul