Forum Discussion

dsun01's avatar
dsun01
Icon for Contributor rankContributor
3 years ago

detail of altera_pcie_gui stop run

Dear Inter support.

I have a PCIe project on A10, while I am not very confident that the platform is working. I decide to use the altera_pcie_gui to verify it.

I downloaded the FPGA and driver, on win7. I believe I followed the instructions carefully, but the program still not working.

I attached a file that describes my setup and execute procedure.

hope someone who had run the program successfully before can give me some suggestions.

thank you very much.

David

4 Replies

  • Wincent_Altera's avatar
    Wincent_Altera
    Icon for Regular Contributor rankRegular Contributor

    Hi,

    I wish to follow up with you about this case.

    Do you have any further questions on this matter ?

    ​​​​​​​Else I would like to have your permission to close this forum ticket

    Regards,

    Wincent_Intel


  • Wincent_Altera's avatar
    Wincent_Altera
    Icon for Regular Contributor rankRegular Contributor

    Hi,

    I wish to follow up with you about this IPS case.

    Hoping to hear back from you so that we can proceed for next step.

    Regards,

    Wincent_Intel


  • Wincent_Altera's avatar
    Wincent_Altera
    Icon for Regular Contributor rankRegular Contributor

    Hi David

    We have not hear from you and this Case is idling. It is not recommended to idle for too long.

    Therefore following our support policy, I have to put this case in close status. My apologies if any inconvenience cause

    Hence, This thread will be transitioned to community support.

    If you have a new question, feel free to open a new thread to get support from Intel experts.

    Otherwise, the community users will continue to help you on this thread. Thank you

    If you feel your support experience was less than a 9 or 10,

    please allow me to correct it before closing or let me know the cause so that I may improve your future support experience.

    Regards,

    Wincent_Intel