Forum Discussion
DE10-Nano, IP UART, GPIO pins
- 2 years ago
Hi,
Here are the screenshot examples to use UART to map to GPIO:
1)Exporting as conduit
2) Connect rx and tx to GPIO
3) Example of Pin Assignment assigning to board's GPIO with link of DE10 Nano user(page 29, table 3-10) manual: https://www.intel.com/content/dam/develop/external/us/en/documents/de10-nano-user-manual.pdf
Thank you.
Regards,
Kelly
Hi
Since a solution have been provided and no feedback was received, I shall set this thread to close pending. If you still need further assistance, you are welcome reopen this thread within 20days or open a new thread, some one will be right with you. Please login to ‘https://supporttickets.intel.com’, view details of the desire request, and post a feed/response within the next 15 days to allow me to continue to support you. After 15 days, this thread will be transitioned to community support. The community users will be able to help you on your follow-up questions.
If you happened to close this thread you might receive a survey. If you think you would rank your support experience less than 10 out of 10, please allow me to correct it before closing or if the problem can’t be corrected, please let me know the cause so that I may improve your future service experience.
Regards
Jingyang, Teh