Forum Discussion
jackhab
Occasional Contributor
Occasional ContributorDE10-nano HPS boot from flash
Hello
I was trying program bootloader to DE10-nano evaluation board and got the following error:
$ quartus_hps.exe -c 1 -o PV 'c:\My\1609\preloader-mkpimage.bin' Current hardware is: DE-SoC [US...
aikeu
Regular Contributor
Regular ContributorHi jackhab,
I think the schematic you are looking at is a base reference for other Cyclone V models as well.
Refer to the link below from Terasic Wiki, DE10 Nano doesnt have NAND and QSPI flash mounted on the board:
Thanks.
Regards,
Aik Eu
jackhabOccasional Contributor
Occasional ContributorHi Aik,
This is a bit strange because I when take the SD card out and set the MSEL switch to QSPI mode the board has FPGA configured after reset - the orange conf LED is on and user LEDs are blinking with a nice looking pattern. Probably, this Wiki page is not up to date.
I suspect the problem is that Golden Reference design does not have QSPI as HPS peripheral.
