Forum Discussion

Sameer-sahu's avatar
Sameer-sahu
Icon for Occasional Contributor rankOccasional Contributor
2 years ago
Solved

Cyclone V E FPGA development kit not responding

Currently, we brought a new Cyclone V E development board kit. On 5th April 2023, we tried to flash a simple blink-led FPGA code into the device by connecting the board through the web UI portal. The...
  • Sameer-sahu's avatar
    Sameer-sahu
    2 years ago

    This issue is resolved. Actually I didn't configure JTAG DPI switch perfectly. Thats why JTAG port was not working.

lixy's avatar
lixy
Icon for Contributor rankContributor
2 years ago

Hi there,


I can not find the screenshot you mentioned. Can you try to upload it again?

Let me first figure out the situation: You tried both Web UI and Quartus Programmer software to connect to the Devkit through JTAG. Both of them cannot connect to the FPGA. Programmer detects a wrong JTAG ID.


Thanks & Regards,

Xiaoyan


  • Sameer-sahu's avatar
    Sameer-sahu
    Icon for Occasional Contributor rankOccasional Contributor
    2 years ago

    Hi lixy, thanks for the response, appreciate it
    I have attached the image(current state of the kit and current state of auto-detect in programmer),

    what you figured is right, Earlier(when the kit was responding) in the programmer while giving auto-detect, it never detected the board with correct part number (5CEFA7F31I7), it was showing something similar to this but exactly not this.